Post by account_disabled on Dec 12, 2017 12:50:26 GMT 8
Hello,
I have a Hatchbox Alpha and lately I cannot get ABS or PLA (the only kinds of filament I have) to stick. For whatever reason unknown to me, the filament constantly runs out of the nozzle, and while it may be slow, it is annoying because every 30 seconds there is a bit of filament i have to scrape off the nozzle. The filament also doesn't seem to stick to the bed as I have adjusted the Z coordinates, I have adjusted temperature up and down on both the bed and the nozzle, and I have cleaned the glass to look like new. I have tried on heat tape, painters tape, I've tried using glue, and I've tried using hairspray, yet I cannot get the filament to stick as it just curls up around the nozzle.
Please help.
Thanks
I didn't find the right solution from the Internet
References:
www.3dhubs.com/talk/thread/hatchbox-alpha-nozzle-issues
Technology Explainer Video
I have a Hatchbox Alpha and lately I cannot get ABS or PLA (the only kinds of filament I have) to stick. For whatever reason unknown to me, the filament constantly runs out of the nozzle, and while it may be slow, it is annoying because every 30 seconds there is a bit of filament i have to scrape off the nozzle. The filament also doesn't seem to stick to the bed as I have adjusted the Z coordinates, I have adjusted temperature up and down on both the bed and the nozzle, and I have cleaned the glass to look like new. I have tried on heat tape, painters tape, I've tried using glue, and I've tried using hairspray, yet I cannot get the filament to stick as it just curls up around the nozzle.
Please help.
Thanks
I didn't find the right solution from the Internet
References:
www.3dhubs.com/talk/thread/hatchbox-alpha-nozzle-issues
Technology Explainer Video